Autocom CDP Pro avtivate and get activation code instruction
- SETUP software (start.exe ) ,
- write product id (for cars: a-710-479 ) , ( for trucks : a-710-254 )
- Write the S/N and Hardware Key ( for Cars : serial number; 30250, HW key; MNZTTOOCNHVE) ( for Trucks : serial number; 39071, HW key; PUKRJOIVQTYX )
- click ON ” Activate via USB ”
- and you will have the "FileActivation.xml" file in USB-memory stick
- Post this FileActivation.xml file to me [email@example.com]
Then I will send you a new FileActivation.xml file., copy into USB-memory stick .
And connect to USB-memory stick to computer. software will get infos in.
If not you can select to Manuel mode and open xml file
Eject to USB-memory
Software will open then will have an error (Failed to load vehicle ……)
Run " Update_3_-_2011_Release_3" write product id (for cars: a-710-479), (for trucks: a-710-254)
Software will open!!
If you used old version autocom, in order to use interface you need to update firmware:
Connect interface to car. (for power )
Setting, HW test, it will have a message asking about firmware update. Click OK and it will make firmware update.
You need to wait few minute for firmware update. (During firmware update, don’t close software or don't remove power)
Then you can use autocom 2011 release3
If I setup autocom car 2011.03 on other computer, do I need activation?
Yes, autocom CDP Pro for car 2011.03 is only offered with one time free active service, if you want to install autocom for car 2011.03 on other computer, you have to reactive again.
アフターサービスについて: Contact our Customer Service Department. (サービスの担当者はすぐに対応する。)
てください。ログイン first if you want to later edit or manage reviews uploaded by yourself.